to Log Index
Task: Brake Pedals
I drilled the F-6116 & F-6115 rudder pedal bearing blocks
to #10 by marking per the plans. I then cut F-6115 in half
by scribing a line 7/8 from both the top and bottom to find
center. The band saw worked well for this task.
I used AutoCAD to draw the rivet hole locations on the F-790
elevator pushrod assembaly. I printed the drawing, cut it
out, and taped it to the pushrod. I then used a center-punch
to mark the hole and a drill-press to drill it.
Next we cutout the
F-635 elevator bellcrank. I had to drill an extra hole 2.5"
from the center bearing hole for the autopilot pitch servo